Xiamen-e Chak Instrument Co. sterile saline ice machine 20N-40 stock quotes [Instrument] Chak-e model ice machine 20N-40 is used to produce a stained-free soft spikes of ice mud, mud is the ice in order to meet the need for surgery. Ice is determined by the amount of mud surgeon, ice mud once the maximum amount of 6,000 ml. The following steps show you from the boot device to produce ice mud the whole process. Also be sure to follow all disinfection procedures standard hospital disinfection. 1. Plug in 220V supply voltage. 2. Press the control switch, press-on supply. At this time the red light. 3. Add the heat transfer medium (capacity 1200ML-1300ML) to insulated steam room, thermal conductivity media by the hospital of their choice. The media must meet two conditions: ① has good thermal conductivity. ② at -32. 7 ℃ will not freeze. 4. suggested the use of 50% alcohol plus water. Before adding coolant after the addition of cold heat transfer medium needs to be set for 15 minutes. 5. After setting cold sterilizing conditions to sterilize the cloth cover on ice machine to disinfect the flaps on the insulating vapor, but do not cover the louvers. 6. In accordance with sterile conditions and gently set after disinfection sterilization bag into the steam pot ice wells. 7. 1.4 liters of normal saline was added to the pot, in order to shorten the freezing time, saline need precooled to 4 ℃. 8. After 15 minutes, when the melting ice is formed, with onboard polycarbonate shovel (rigorous disinfection) for melting ice, until the formation of the desired ice slurry. If not used immediately, the ice will be frozen on both sides of the mud pots, and once this happens, again stirring with a shovel until the formation of ice slurry can be used. 9. Ice mud after use as needed, an appropriate amount of saline may be added as appropriate, repeat the above steps. If not required, turn off the power, clean up the waste basin. 10. put a drain on the medical Xiaopen, the ice machine is located in the bottom right corner drain, drain valve loosened by hand in the middle of the steam chamber, until all the heat exchange fluid drained to Xiaopen date, and finally the drain valve tighten. Icemaker comprehensive parameter 1. pots filled ice load capacity of about 6 liters, easy to move, easy to disinfect. 2. The one-touch control switch. 3. agitator wear-resistant plastic, can be gas sterilized or heat sterilization. The freezing point of -37 ℃. 5. Ice mud a maximum amount of 6000 ml. 6. Power Requirements: 220V / 50HZ / 1 phase 7. Dimensions (width × depth × height): 448 × 419 × 914